Baby Steps

Took a rest day yesterday, though I should start doing an active recovery day once a week again. Middle of my back, or just below my shoulder blades, especially on the sides of my spine, is was really tight. Not as bad today. Went to the 4pm class.

Warm-up

  • 2 Minute Row (28 s/m)
  • 2 Rounds
    • 10 Push-ups
    • 10 Air Squats
    • 10 American KBS (35#)

Conditioning

  • Buy In: 3,000m Row
  • 5 Rounds
    • 15 Push Jerks (95#)
    • 15 Sit-ups
    • 15 American KBS (53#)

Started out around 1:51/500m and then slowed closer to 1:55 after about 1,000 meters with a stroke rate around 25-26 most of the way. I got off the rower around 11:20-ish and was feeling good, so I know I didn’t go too hard. When I saw this workout I knew I wasn’t going to try 115# and 70#. I made the right choice with scaling. Still had to break up the last two rounds of push jerks because I couldn’t straighten my arms! I went 8-7 and 9-6 on those rounds. Tried to catch my breath on the sit-ups and did the swings unbroken every round. Going from the swings to the jerks was horrible. Finished in 22:21.

Skill

Worked on finding balance in a handstand hold and some walking again. My shoulders were wrecked, but I figured it would be good practice when fatigued. The band across the rig was feeling good, so I went over to the wall and started taking a few handstand steps into it and was even able to hold in a freestanding for a little bit. Felt like a huge breakthrough today!

Published by

Nick Momrik

I'm searching for the perfect golf swing and my first hole-in-one. I'm addicted to CrossFit. I work for Automattic.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s